Lehenga Saree Draping: How to Wear a Saree Lehenga Style, Step by Step
By Nishita Nathani17 min read
To drape a saree lehenga style, tuck the plain end just right of your navel over a flared petticoat, wrap it once, then make small pleats and tuck them in one by one all the way round your waist, so the lower half falls like a lehenga skirt. The rest goes across your front and over your left shoulder as the pallu, worn pleated or open like a dupatta. This guide shows the pleat path round the waist, how much of a 5.5 m saree the pleats will use for your waist size, four ways to wear the pallu, and what to do when the skirt looks flat or the pallu comes up short.
What a Lehenga Saree Is
A lehenga is an ankle-length flared skirt, worn with a choli (blouse) and usually a dupatta. Across India similar flared skirts go by other names, such as ghagra, chaniya in Gujarat and Rajasthan, or langa in the south. A lehenga saree borrows that shape from a single unstitched saree: instead of one bank of pleats at the navel, the pleats go all round the waist, and the pallu does the job of the dupatta.
People use the name for two different things, and it helps to know which one you are looking at:
This guide is about the first: turning a saree you already own into a lehenga look for the evening. It differs from a half saree, which is a separate skirt, blouse and half-length voni. For how the half saree, the saree and the lehenga choli compare, and the shortest version of this drape, see our half saree guide.

What You Need Before You Start
Most of the flare in a lehenga style drape comes from what is underneath. A straight petticoat gives you a saree with a lot of pleats; a flared one gives you a skirt.
Tie the petticoat snugly at the height you want the skirt to sit, knotted at one side, not the centre front. For sizes and colours, see our saree petticoat guide. Under a light saree, a petticoat close to your skin tone or to the saree colour shows less than white.
How Much Fabric the Pleats Take
This is the part that catches people out. Pleating all round the waist uses far more cloth than five to seven front pleats, so you need to know before you start whether your saree will leave enough for a pallu.
Each small pleat that shows about an inch on the outside hides roughly two more inches folded behind it. So a full round of pleats uses about three times your waist measurement. On a 5.5 m saree, after the first wrap and the length that crosses your front, what is left becomes the pallu.

These figures assume a first wrap of about 1 m and about half a metre crossing your front. Every MAYIN saree is 5.5 m long and 45 inches wide, and any blouse piece is extra to that length, so the full 5.5 m is yours to drape once it is cut off. A longer saree, 6 m or more, gives you an easier open pallu.
How to Drape a Saree Lehenga Style
The order is the same as a nivi drape: tuck, wrap, pleat, pallu. The difference is that the pleats keep travelling round the waist instead of stopping at the navel.

If you have done the short four-step version from our saree draping styles guide, this is the same drape with each stage slowed down. The one thing to keep in mind is direction: the wrap and the pleats travel the same way round your body, so the fabric never has to double back.
Getting the Pleats Right All Round
Lehenga pleats are smaller than nivi pleats and there are many more of them, so small faults add up. A few habits make the difference:
Folding the front set before you tuck, as you would for a nivi drape, works for the front third. For the back, it is easier to fold and tuck one pleat at a time. Our saree pleats guide covers folding, pressing and the even-hem trick in detail.
Pleats facing left at the front match the way a nivi drape is pleated, so the look stays familiar from the front. On a printed saree, try to bring the same part of the print to the top of each pleat; on stripes or checks, line up one stripe at each fold.
Four Ways to Wear the Pallu
The pallu is the dupatta of this look, and it changes the whole outfit. All four styles below start from the same pleated skirt.

The front pallu needs the most length, because it goes round the back first. If you like that finish, our seedha pallu guide walks through the shoulder and pinning in detail. For belts that sit flat over pleats, see our saree belt guide.
The Petticoat and Blouse
Avoid a mermaid or shapewear petticoat for this drape. It narrows at the knee, which is the opposite of the shape you want.
The blouse is the other half of the look. Because the pleats cover the whole lower half, a structured or embellished blouse balances them: a sweetheart or square neck, elbow sleeves, or a blouse in a colour picked from the saree border, which gives a two-tone lehenga choli feel. A cropped blouse that ends a little higher than usual shows a strip of waist, like a lehenga choli; a standard length keeps it more saree-like.
Which Sarees Work Best
Almost any saree can be draped this way, but some make it easier. Lightness matters most, because twenty or so pleats of a heavy saree add a lot of bulk at the waist.
A saree with a defined lower border works especially well: once pleated all round, that border becomes a continuous lehenga hem. All-over prints, leheriya and sequins also suit the drape because they look good from every side of the skirt.
Fixes for Common Problems
For which pins to use and where, see how to pin a saree. Carry two or three spares in your bag; the back pleats are the ones that loosen first.
Ready-Made Lehenga Sarees vs Draping Your Own
A ready-made lehenga saree is stitched: the skirt has its pleats sewn in and the pallu is attached, so you step in, fasten and pin the pallu. It saves time and is consistent, but you cannot wear it any other way.
There is a middle way. You can pleat a saree once and hold the skirt pleats with a few stitches or a waistband so it goes on in minutes, without cutting it. Our pre-draped saree guide explains how.
Sarees in This Guide
Light sarees with a pattern that looks good from every side are the easiest to wear lehenga style. Our chiffon sarees fall softly over a can-can, tissue sarees give a crisp, festive skirt, and mul cotton sarees are the easiest to practise on. Every MAYIN saree is 5.5 m long and 45 inches wide, and delivery in India is free on orders of ₹2,000 and above.
ElysiaPink floral print pure chiffonPair with Gold, ivory
Rouge WavesPink leheriya print pure chiffonPair with Silver, fuchsia
StarletWine sequin pure chiffonPair with Gold, blush pink
Miss Earth Tissue SareeMiss earth tissuePair with Gold, maroon
Bright SideWhite mulmul cotton with yellow borderPair with Yellow, red
Mauve MelodyPlain pink mul modalPair with Silver, wine
Elysia (₹3,399) and Rouge Waves (₹3,999) are pure chiffon with an all-over print, so the skirt looks the same from every side. Starlet (₹5,999) is a sequin pure chiffon for a sangeet or cocktail evening. All three come with a 1 m crepe blouse piece and are dry clean only. The Miss Earth Tissue Saree (₹3,499) is a handloom tissue that holds a little flare on its own; it has no blouse piece and is dry clean. Bright Side (₹1,999), a mul cotton with a yellow border that becomes the lehenga hem, has no blouse piece and takes a gentle cold hand wash. Mauve Melody (₹1,899) is a soft mul modal with a 1 m running blouse piece in the same fabric, and also takes a gentle cold hand wash.
Planning a sangeet look? Our sangeet saree guide covers colours, blouses and drapes that stay put through a dance.
Questions People Ask
How do you drape a saree in lehenga style step by step?
Tuck the plain end just right of your navel over a flared petticoat and wrap once. Make small pleats and tuck them one by one all round your waist, then take the rest across your front and over your left shoulder, and pin at the shoulder and left waist.
What is a lehenga saree?
It is a saree worn so the lower half looks like a lehenga skirt, either by pleating a regular saree all round the waist or as a ready-made garment with a stitched, pre-pleated skirt and an attached pallu.
What is the difference between a saree and a lehenga saree?
A saree is one unstitched length with pleats at the navel only. A lehenga style saree uses the same length, pleated all round the waist over a flared petticoat, with the pallu worn like a dupatta.
Do I need a can-can for a lehenga style saree?
Not always, but a flared or can-can petticoat gives the skirt its shape. Without one, two ordinary petticoats layered together give some lift, and crisp fabrics like tissue need less help than chiffon.
How many metres of saree are needed for a lehenga style drape?
A 5.5 m saree, about six yards, is enough for most people. The pleats use roughly three times your waist, so a larger waist may need front-only pleats or no first wrap to leave a pallu.
Can I drape a cotton saree in lehenga style?
Yes. A light mul cotton is one of the easiest sarees for this drape because it holds small pleats without slipping. Thicker cottons add bulk at the waist, so keep the pleats small.
Which fabric is best for a lehenga style saree?
Light fabrics are easiest: chiffon, tissue, mul cotton and mul modal. Heavy silks give a dramatic flare but need smaller pleats and more pins to manage the bulk at the waist.
Can you make a saree into a lehenga?
You can drape one to look like a lehenga without cutting it, as this guide shows. You can also stitch the pleats to a waistband for a quick pre-draped version, or have a tailor make a lehenga from it, which uses up the saree.
Is a lehenga style saree good for a wedding?
It suits sangeet, mehendi, reception and cocktail evenings well, especially in sequin, tissue or a heavy-bordered saree. For a ceremony with a lot of sitting, pin the back pleats securely.
How long does a lehenga style drape take?
Allow about 20 minutes the first time, as there are many more pleats than a nivi drape. With practice it takes roughly ten to fifteen minutes.
How do I stop the pleats coming out at the back?
Pin every five or six pleats to the petticoat from the inside, tuck about 2 inches deep, and check the back in a second mirror. Carry a couple of spare pins.
Which side does the pallu go on in a lehenga style saree?
Usually over the left shoulder, as in a nivi drape. For a front pallu, take it round the back and bring it over the right shoulder instead.
Share
Keep reading